HP Color LaserJet 4650 Printer series - Manual (Page 80)

13. Press to select LOCAL GATEWAY or DEFAULT GATEWAY.
Note The first set of the three sets of numbers shows the default settings. If there is not a number
highlighted, a highlighted empty underscore appears.
14. Press or to increase or decrease the number for configuring LOCAL or DEFAULT
GATEWAY.
15. Press to move to the next set of numbers.
16. Repeat steps 15 and 16 until the correct subnet mask is entered.
17. Press the M
ENU
button to return to the Ready state.
Disabling network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols
has the following benefits:
● decreases printer-generated network traffic
● prevents unauthorized users from printing to the printer
● provides only pertinent information on the configuration page
● allows the printer control panel to display protocol-specific error and warning messages
Note TCP/IP configuration cannot be disabled on the HP Color LaserJet 5550 series printer.
To disable IPX/SPX
Note Do not disable this protocol if Windows 95/98, Windows NT, ME, 2000, and XP users will be
printing to the printer.
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press to select EIO X.
8. Press to highlight IPX/SPX.
9. Press to select IPX/SPX.
10. Press to highlight ENABLE.
11. Press to select ENABLE
12. Press to highlight ON or OFF.
13. Press to select ON or OFF.
14. Press the M
ENU
button to return to the Ready state.
To disable DLC/LLC
1. Press M
ENU
to enter the MENUS.
66 Chapter 3 I/O Configuration ENWW