HP XP Racks User Manual
Page 54
Figure 10 LUN Configuration
RAID Manager uses absolute LUNs to scan a port, whereas the LUNs on a group are mapped for
the host system so that the target ID & LUN, which is indicated by the raidscan command, is different
from the target ID & LUN shown by the host system. In this case, the target ID & LUN indicated by
the raidscan command should be used.
In this case, you must start HORCM without a description for HORCM_DEV and HORCM_INST
because target ID & LUN are unknown. Use the port, target ID, and LUN displayed by the raidscan
-find or raidscan -find conf command for HORCM_DEV (see
Example 8 “Displaying the Port, TID,
).
For details on LUN discovery based on a host group, see Host Group Control in the HP XP7 RAID
Manager User Guide.
Example 8 Displaying the Port, TID, and LUN Using raidscan
# ls /dev/rdsk/* | raidscan -find
DEVICE_FILE UID S/F PORT TARG LUN SERIAL LDEV PRODUCT_ID
/dev/rdsk/c0t0d4 0 S CL1-M 0 4 31168 216 OPEN-3-CVS-CM
/dev/rdsk/c0t0d1 0 S CL1-M 0 1 31168 117 OPEN-3-CVS
/dev/rdsk/c1t0d1 - - CL1-M - - 31170 121 OPEN-3-CVS
UID: displays the UnitID for multiple RAID configuration. If UID appears as '-' then the command
device for HORCM_CMD is not found.
S/F: displays that a PORT is SCSI or fibre.
PORT: displays the RAID storage system port number.
TARG: displays the target ID (converted by the fibre conversion table, see
).
LUN: displays the Logical Unit Number (converted by the fibre conversion table).
SERIAL: displays the production number (serial#) of the RAID storage system.
LDEV: displays the LDEV# within the RAID storage system.
PRODUCT_ID: displays product-id field in the STD inquiry page.
54
Fibre-to-SCSI address conversion