HP XP Racks - Manual (Page 23)

$ DEFINE DECC$ARGV_PARSE_STYLE ENABLE
$ SET PROCESS/PARSE_STYLE=EXTENDED
where Device:[directory] is defined as SYS$POSIX_ROOT
For Installing:
$ PRODUCT INSTALL RM /source=Device:[directory]/LOG -
_$ /destination=SYS$POSIX_ROOT:[000000]
Device:[directory] where HITACHI-ARMVMS-RM-V0122-2-1.PCSI exists
:
:
$ PRODUCT SHOW PRODUCT RM
----------------------------------------- ----------- ------------
PRODUCT KIT TYPE STATE
----------------------------------------- ----------- ------------
HITACHI ARMVMS RM V1.22-2 Full LP Installed
----------------------------------------- ----------- ------------
$ raidqry -h
Model : RAID-Manager/OpenVMS
Ver&Rev: 01-22-03/06
:
:
For Installation history:
$ PRODUCT SHOW HISTORY RM /FULL
For removing :
$ PRODUCT REMOVE RM /LOG
(13) About exit code of the command on DCL
RAID Manager return codes are the same for all platforms. However, if the process was invoked
by the DCL, the status is interpreted by DCL and a message appears as below.
-------------------------on DCL of OpenVMS------------------------
$ pairdisplay jjj
PAIRDISPLAY: requires '-jjj' or '/jjj' as argument
PAIRDISPLAY: [EX_REQARG] Required Arg list
Refer to the command log(SYS$POSIX_ROOT:[HORCM.LOG]HORCC_RMOVMS.LOG (/HORCM/log/horcc_rmovms.log))
for details.
$ sh sym $status
$STATUS == "%X0035A7F1"
$
$ pairdisplay -g aaa
PAIRDISPLAY: [EX_ATTHOR] Can't be attached to HORC manager
Refer to the command log(SYS$POSIX_ROOT:[HORCM.LOG]HORCC_RMOVMS.LOG (/HORCM/log/horcc_rmovms.log))
for details.
$ sh sym $status
$STATUS == "%X0035A7D9"
------------------------on DCL of OpenVMS-------------------------
You can calculate the RAID Manager "Exit code" from $status of DCL using the formula below.
Exit code of RM command = ( $status % 2048 ) / 8
Known issues
Rebooting on PAIR state (Writing disable)
OpenVMS does not show the volumes of writing disable (for example, SVOL_PAIR) at start-up of
system, therefore the S-VOLs are hidden when rebooting in PAIR state or SUSPEND(read only)
mode. You are able to verify that the "show device" and "inqraid"command does not show the
S-VOLs after reboot as below (notice that DGA148 and DGA150 devices are SVOL_PAIR).
$ sh dev dg
Device Device Error Volume Free Trans Mnt
Name Status Count Label Blocks Count Cnt
$1$DGA145: (VMS4) Online 0
$1$DGA146: (VMS4) Online 0
$1$DGA147: (VMS4) Online 0
Porting notice for OpenVMS 23