HP Optical Jukeboxes - Manual (Page 54)

3-20 Chapter 3
Operating the Jukebox
Setting an Operating Configuration
Table 3-1 Configuration Choices
Configuration
Name
Description
RECOVERY
ON/OFF
Toggles between ON and OFF. If the configuration is
set to ON, the jukebox attempts to recover from errors;
if the configuration is set to OFF, the jukebox
immediately stops moving if an error condition occurs.
The default configuration is RECOVERY ON, and
recovery should remain ON under normal conditions.
RESTORE
DEFAULTS
Sets all jukebox configurations to default settings.
CLEAR
ODOMETERS
Used by service personnel only. Sets all jukebox
odometers to zero.
DUAL PICKER
ON/OFF
Toggles between ON and OFF. (The default setting is
DUAL PICKER ON
, and dual picker mode should
remain ON under normal conditions.) If the
configuration is set to ON, the jukebox runs with dual
picker (disk transport) addressing ON; if the
configuration is set to OFF, the jukebox runs with dual
picker (disk transport) addressing OFF.
STARWARS
ON/OFF
Used by service personnel only. Should be set to ON
during normal operation. Toggles between ON and
OFF
. The ON configuration enables the vertical
sensors; the OFF configuration disables the vertical
sensors.
NEW PASSWORD Allows you to change the numerical password required
to access the menu choices under the ADMIN * menu
on the jukebox control panel. These choices include
configurations, tests, and information logs. To change
the security code, see “Changing the Administration
Menu Password” in this chapter.
SCSI LOG
ON/OFF
Used by service personnel only. Should be set to OFF
during normal operation. Toggles between ON and
OFF
. Tracks internal SCSI states and saves the
information to a log.