Connecting power, Power:connecting, Note use the power cord shipped with the jukebox – HP Optical Jukeboxes User Manual

Page 25: Turn the power on, Testing, Note if, Connecting power -13

Chapter 1

1-13

Setting Up the Jukebox

Connecting Power

Ch
ap
ter
1

: Setti

th
e Disk

Dri

ettin
g

th
e

Juke
b

Connecting Power

1. Ensure the power switch on the jukebox is OFF (see Figure 1-1).)

NOTE

Use the power cord shipped with the jukebox.

2. Plug the socket end of the power cord into the power port on the bottom of the

interface enclosure (see “8” on Figure 1-2).

3. Plug the other end of the power cord into a power outlet.

(After the jukebox is moved to its operating location) Lower the leveler feet and
tighten the 1/2-inch nut on each foot.

5. Turn the power on.

TESTING

and NOT READY alternately display. Once the poweron test

completes (approximately 1.5 minutes), READY displays.

NOTE

If DEVICE FAILED displays. See “Troubleshooting” in Chapter 3 for
troubleshooting procedures.

NOTE

Go to “Configuring Write Verify” on the next page to complete the installation.