HP Optical Jukeboxes - Manual (Page 50)

3-16 Chapter 3
Operating the Jukebox
Setting the SCSI IDs
You may now view the SCSI ID and LUN numbers using VIEW ID’S, or set a
new SCSI ID number using SET ID’S. (See the following two sections.)
Viewing the Current SCSI IDs
READY > ADMIN * > SCSI ID’S * > VIEW ID’S * >
NOTE If you are unfamiliar with basic SCSI addressing or LUN addressing, refer to
Appendix B.
Start with READY in the display.
1. Press NEXT until ADMIN * displays, and then press ENTER .
2. Enter the administration password.
Instructions for entering this password are in “Entering the Administration
Menu Password” previously in this chapter.
3. Press NEXT until SCSI ID’S displays, and then press ENTER .
4. VIEW ID’S displays. Press ENTER .
5. JKBX ID # LUN # or DRV # ID # LUN # displays. (JKBX ID # stands
for the current ID of the jukebox controller, DRV # ID # is the current ID
setting of the displayed drive number, and “LUN #” is the current logical unit
number.)
Press NEXT or PREV to scroll through the current SCSI IDs and LUNs.
NOTE Tables in Appendix B show the default SCSI IDs and LUNs when LUN mode is
turned on.
6. Press CANCEL twice to exit VIEW ID’S.