HP BD-2000 Blu-ray Disc Player - Manual (Page 26)

26
Playbac
k
Forward or Reverse
Playback
Blu-ray
DVD
AVCHD
VCD
1 During playback, press or to reverse
or advance playback.
2 Press the button repeatedly to switch
scanning speed (2x, 4x, 8x, 16x, 32x, 64x,
128x).
Note:
You can also reverse or forward scan by holding
the button down. Normal playback resumes
when the button is released.
3 To resume normal playback, press .
Some discs will automatically resume
normal playback when switching to a
new chapter.
Notes:
When scanning Blu-ray, DVD, and VCD discs, •
no sound output is produced.
Sound is output during CD-Audio disc
•
scanning.
Playback Controls
Some discs start playing automatically after
the Blu-ray player loads the disc. If not, use
the remote control to start playback.
1 Press to start playback.
To pause, press
•
.
To stop playback, press
• .
To resume playback, press
•
again.
2 When playback is finished, press to
open the disc tray.
3 Remove the disc, then press to close
the disc tray.
4 Press to turn off the Blu-ray player.
Resuming playback
»
Some discs do not support the resume •
playback function.
When
• is pressed, the point where it
stopped is saved in the Blu-ray player’s
memory. When is pressed, playback
resumes from the point where it stopped.
The resume settings are cleared when:
When the Blu-ray player’s power is •
turned off.
To cancel resume playback, press • twice.
WARNING
Do not leave the disc inside the Blu-ray player.