HP LD5535 55-inch LED Digital Signage Display - Manual (Page 98)

00 to 50 (00H to 32h)
** It may not be supported depending on the model.
Acknowledgement
[h][ ][Set ID][ ][OK/NG][Data][x]
32. Natural Mode (In Tile Mode) (Command : d j)
To display the image naturally, the part of the image that would normally be displayed in the gap between
the displays is omitted.
Transmission
[d][j][ ][Set ID][ ][Data][Cr]
Data
00: Off
ff: Read Status
Acknowledgement
[j][ ][Set ID][ ][OK/NG][Data][x]
33. DPM Select (Command: f j)
To set the DPM (Display Power Management) function.
Transmission
[f][j][ ][Set ID][ ][Data][Cr]
Data
00: Off
01: On
Acknowledgement
[j][ ][Set ID][ ][OK/NG][Data][x]
34. Temperature Value (Command: d n)
To check the inside temperature value.
Transmission
[d][n][ ][Set ID][ ][Data][Cr]
Data
FF: Check the status
Acknowledgement
[n][ ][Set ID][ ][OK/NG][Data][x]
* Temperature is displayed in hexadecimal.
88 Chapter 12 Controlling multiple products