HP 3PAR Application Software Suite for Microsoft Hyper-V - Manual (Page 78)

Table 41 Create-vCopy parameters (continued)
Description Optional/Required Parameter
The Virtual Copy name prefix. A unique
timestamp will be generated for this Optional -VcNamePrefix
new Virtual Copy and appended to this
prefix. If not specified, the VC name
will be vc-timestamp where
timestamp is generated for this new
Virtual Copy.
Integer value followed by letter h or d
for Hours and Days respectively Default:
use the RMH Policy. Optional -Expiry
Integer value followed by letter h or d
for Hours and Days respectively Default:
use the RMH Policy. Optional -Retention
Disabled or enabled. Optional -SavedStateBackups
Default: use the RMH policy.
Displays progress messages. Optional -Verbose
Result with Description
•
Multiple {RmhCreateVirtualcopyResult} objects.
◦ VM Name or UUID
◦ Success/Failure status of the create-vCopy operation for the VM
◦ Detailed error message(s) when operation fails
◦ An instance of an object of type RMHVirtualcopySet describing created Virtual Copy
set.
Success Paths
•
Scenario 1: Virtual Copies are successfully created.
Virtual Copies on VM(s) specified are successfully created.
Failure Paths
•
Scenario 1: Session owner is invalid.
Every session command received on RMH Server is validated to originate from the same IP
address that initiated the session. If IP does not match, the command fails.
•
Scenario 2: Storage System session credentials are not provided.
Storage System session credentials are not provided for this command.
•
Scenario 3: No VM is specified.
At least one VM must be specified for command.
•
Scenario 4: Cannot communicate with the VMs.
VM is specified, but RMH Server cannot communicate with specified VMs.
•
Scenario 5: Expiry is invalid.
Expiry specified is invalid. Valid: 1-43800h, 1-1825d.
•
Scenario 6: Retention is invalid.
Retention specified is invalid. Valid: 1-336h, 1-14d.
78 HP 3PAR Recovery Manager for Microsoft Hyper-V Powershell Commands