HP 3PAR Application Software Suite for Microsoft Hyper-V - Manual (Page 55)

5 Using PowerShell Snap-in Command Line Interface
HP 3PAR Recovery Manager for Hyper-V includes custom Powershell snap-in as the default client
interface and provides essential command lines for administrative tasks.
NOTE: For the list of all command used in Recovery Manager for Hyper-V, see “HP 3PAR Recovery
Manager for Microsoft Hyper-V Powershell Commands” (page 73)
Connecting to RMH Server
Use the following command lines to establish a session with the Microsoft Hyper-V server.
Login-Rmh
Log on to RMH Server using Windows RMH account.
The optional login-Rmh enables the user to log on to Recovery Manager for Hyper-V. After a
successful login is established, the user is not required to enter additional credentials for subsequent
Cmdlets.
Syntax
Any optional parameters are enclosed in square brackets [ ] around them.
Login-Rmh-RmhServerName <-RmhServerName>-RmhUserName
<-RmhUserName>-RmhPassword <-RmhPassword>[-RmhEncrytedPassword]
Table 20 Login-Rmh parameters
Description Optional/Required Parameter
Host name of the RMH Server. This is
FQDN or IP address. Required -RmhServerName
RMH user name. If not specified, a
dialog box will be presented to enter
credentials. Required -RmhUserName
RMH user password. If not specified, a
dialog box will be presented to enter
credentials. Required -RmhPassword
May be used instead of
-RmhPassword -RmhEncrytedPassword
Logout-Rmh
The optional logout-Rmh Cmdlet logs off the user from the application.
Preconditions
The user must first login with Login-Rmh.
Syntax
Any optional parameters are enclosed in square brackets [ ] around them.
Logout-Rmh -RmhServerName
Table 21 Logout-Rmh parameters
Description Optional/Required Parameter
Host name of the RMH Server. This is
FQDN or IP address. Required -RmhServerName
Connecting to RMH Server 55