HP ProLiant DL385 G7 Server - Manual (Page 55)

Hardware options installation 55
o To remove slot covers 5 and 6, push down on the latch, rotate the latch down, and then remove
the cover.
Installing a half-length expansion board
1. Power down the server (on page 22 ).
2. Extend the server from the rack (on page 22 ).
3. Remove the access panel (on page 23 ).
4. Remove the full-length expansion board retainer (on page 24 ) if any full-length expansion boards are
installed.
5. Remove the PCI riser cage (on page 25 ).
6. Remove the expansion slot cover (" Expansion board options " on page 53 , " Removing expansion
slot covers " on page 53 ).
7. Install the expansion board.
8. Connect any required internal or external cables to the expansion board. See the documentation that
ships with the expansion board.
9. Install the PCI riser cage (on page 26 ).
10. Install the full-length expansion board retainer (on page 26 ) if any full-length expansion boards are
installed.
11. Install the access panel (on page 24 ).
Installing a full-length expansion board
1. Power down the server (on page 22 ).
2. Extend the server from the rack (on page 22 ).
3. Remove the access panel (on page 23 ).
4. Remove the full-length expansion board retainer (on page 24 ).
5. Remove the PCI riser cage (on page 25 ).
6. Install the expansion board.