HP ProLiant DL385 G7 Server - Manual (Page 24)

Operations 24
1. Power down the server if performing a non-hot-plug installation or maintenance procedure (" Power
down the server " on page 22 ).
2. Extend the server from the rack (on page 22 ).
3. Use the T-15 Torx screwdriver attached to the rear of the server to loosen the security screw on the
hood latch.
4. Lift up on the hood latch handle, and then remove the access panel.
Install the access panel
1. Place the access panel on top of the server with the hood latch open. Allow the panel to extend past
the rear of the server approximately 1.25 cm (0.5 in).
2. Push down on the hood latch. The access panel slides to a closed position.
3. Use the T-15 Torx screwdriver attached to the rear of the server to tighten the security screw on the
hood latch.
Remove the full-length expansion board retainer
CAUTION: To prevent damage to the server or expansion boards, power down the server
and remove all AC power cords before removing or installing the PCI riser cage.
1. Power down the server (on page 22 ).
2. Extend the server from the rack (on page 22 ).
3. Remove the access panel (on page 23 ).
4. Remove the full-length expansion board.
o If there are no full-length expansion board installed, remove the full-length expansion board
retainer as follows: