HP ProLiant DL385 G7 Server - Manual (Page 50)

Hardware options installation 50
3 — 3 DR DR 1333 MHz
DR 1066 MHz 1066 MHz 800 MHz
3 — 3 mixed SR 1333 MHz
DR 1333 MHz
DR 1066 MHz 1066 MHz 800 MHz
3 1 2 SR 1333 MHz
DR 1333 MHz
DR 1066 MHz
QR 1066 MHz 800 MHz 667 MHz
— *These are the only configurations supported by UDIMMs. All configurations listed in this
table are supported by RDIMMs.
— LVDIMM support is dependent on the ROM version.
— This table is for reference only. It may not be updated to reflect recent changes.
o 800 MHz—The memory bus speed is set to 800 MHz regardless of the quantity of memory
modules installed, unless the table above reflects a slower memory bus speed.
NOTE: There may be more than one memory bus speed menu option.
Installing DIMMs
CAUTION: For proper cooling do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components,
minimize the amount of time the access panel is open.
1. Power down the server (on page 22 ).
2. Extend the server from the rack (on page 22 ).
3. Remove the access panel (on page 23 ).
4. Remove the air baffle (on page 28 ).
5. Open the DIMM slot latches.