Installing the insight providers smart component – HP Insight Management WBEM Providers User Manual
Page 9
Installing the HP Insight Providers 9
o
Configure WBEM / WMI
o
Use an HP SIM WBEM certificate
o
Configure a non-administrative account for HP SIM to access WMI data
o
Configure SNMP
o
Configure secure shell (SSH) access
o
Set Trust relationship to Trust by Certificate
o
Configure Version Control Agent (VCA)
o
Set administrator password for Insight Management Agents version 7.1 or earlier
For more information, see the HP SIM user documentation.
10.
Click Run Now, or click Schedule, and then set up a schedule to run this task at a later time.
The Task Results page appears and displays the following information:
o
Status—Displays the details for each target system in a task instance.
o
Exit Code—Represents the success or failure of an executable program, but does not indicate
that all attempts succeeded. If the return value is zero or positive, the executable ran successfully.
If the return value is a negative value, the executable failed.
o
Target Name—Displays the name and IP address of the target.
o
The stdout tab—Displays the output text information.
o
The stderr tab—Displays information if the executable experienced an error.
o
View Printable Report—Reports can be printed for the currently selected target system or for all
target systems associated with the task instance.
11.
(Optional) To print a report:
a.
Click View Printable Report.
b.
From the Options Message box, select the report to display.
c.
You can generate a report containing the selected target system or all systems associated with
the task instance.
d.
Click OK to display the report, or click Cancel to return to the View Task Results page.
Installing the Insight Providers Smart Component
IMPORTANT:
This installation method does not apply for HP ProLiant 100 Series servers.
You can install the Insight Providers individually using an Insight Providers Smart Component. Perform this
type of installation to install the Insight Providers without performing a full PSP installation or without using
SmartStart.
IMPORTANT:
You must install PSP 8.40 (or later) before or with Insight Providers 2.5.0. For
ProLiant 100 Series G6 servers, you must install the Easy Setup CD components.
To install the Insight Providers Smart Component:
1.
Verify that the target servers are on the supported hardware list. See "Hardware support (on page
)."