HP NonStop G-Series - Manual (Page 75)

OSS File Synchronization
HP AutoSYNC User’s Guide—522580-016
5-7
Changing Default Ownership of Symbolic Links
Changing Default Ownership of Symbolic Links
To set the owner of a synchronized symbolic link to a user different than the user
performing the synchronization or to set the owner to the user ID specified through the
OWNER or OWNERGROUP option, the destination ASYSYNC process, or
ASYSYNCP if synchronizing over TCP/IP, has to be privileged. A privileged ASYSYNC
or ASYSYNCP if synchronizing over TCP/IP, enables AutoSYNC to switch to the user
ID of the source symbolic link or to the specified OWNER when AutoSYNC creates the
link.
This feature is only supported if the user is SUPER.SUPER (255,255).
To make the destination ASYSYNC, or ASYSYNCP if synchronizing over TCP/IP, a
privileged process, perform the following steps on the destination system after the files
have been moved to the AUTOSYNC subvolume:
1. In BIND issue the following commands:
2. At the TACL prompt, SQL compile ASYSYNCP:
3. At the TACL prompt, accelerate ASYSYNC:
4. Then, as SUPER.SUPER, issue the following command:
If synchronizing over TCP/IP, perform the same steps on ASYSYNCP.
ADD * FROM ASYSYNC
SET LIKE ASYSYNC
ALTER CALLABLE^LOG^DOWN, CALLABLE ON
SET SAVEABEND ON
BUILD ASYSYNC!
SQLCOMP/IN ASYSYNCP/NOREGISTER ON
AXCEL ASYSYNC, ASYSYNC
or
OCA ASYSYNC
FUP LICENSE ASYSYNC
Note. Once you have altered ASYSYNC or ASYSYNCP with the above Binder commands,
ASYSYNC or ASYSYNCP must be licensed or all synchronizations that use that program will
fail.