HP NonStop G-Series - Manual (Page 252)

Error Messages
HP AutoSYNC User’s Guide—522580-016
D-4
Informational messages
111
Cause. An ASYSYNC process has stopped or abended, but no process-stop
message was received. This may be caused by a CPU failure.
Effect. Informational message only; no corrective action is needed.
Recovery. No action is required. The ASYSYNC process is restarted automatically.
112
Cause. Cached configuration information has been refreshed from the MapDB tables.
Effect. The current configuration information is available on request to the monitor.
Recovery. Informational message only; no corrective action is needed.
113
Cause. The USER_AUTHENTICATE_ procedure failed to allow changing the process
access id to another user through a log down.
Effect. Scheduled synchronizations for users other than the AutoSYNC authorizer will
fail.
Recovery. Configure all synchronizations under the AutoSYNC authorizer, or consult
the AutoSYNC documentation for various remedies to enable multiple users to
schedule synchronizations.
114
Cause. A AutoSYNC user is not authorized. The AutoSYNC authorizer is neither the
Super user, the group manager, nor the user.
Effect. No scheduled synchronizations will be performed for the user.
Recovery. A AutoSYNC authorizer with sufficient authority should issue the
AUTHORIZE command as described in the installation procedures. Alternatively,
another user id should be used to configure the SYNCFileset.
ASYSYNC process lost
Monitor cache refreshed
AutoSYNC log down failed
AutoSYNC user not authorized