HP NonStop G-Series - Manual (Page 221)

Operations and Management
HP AutoSYNC User’s Guide—522580-016
A-9
Configuring an Alternate Monitor Process
Create an alternate MapDB
Create the alternate MapDB using the CREATE MAPDB command, specifying the
alternate monitor process name. This command starts the monitor process. In the
example below, the user creates a test MapDB in $DATA.ASZMAPDB with monitor
$ZASZ, from the same alternate product subvolume $data.asyaakts created as an
example above in
Installing an Alternate Version of AutoSYNC .
To configure default values that are specific to the new environment, set LOCAL
parameters to the desired values, using the
ALTER LOCAL command. LOCAL
parameters are the same as GLOBAL parameters, but they apply only to a specific
Monitor and MapDB.
1> $data.asyaakts.autosync
HP Nonstop(tm) AutoSYNC(tm) Command Interpreter(T2713H01) - System \ATOM
(C)2008 Hewlett Packard Development Company, L.P.
(C)2008 Carr Scott Software Incorporated
AutoSYNC 1? create mapdb $data.aszmapdb,monitor $zasz;
--- MapDB table $DATA.ASZMAPDB.REGISTRY created.
--- MapDB table $DATA.ASZMAPDB.SYNCUSER created.
--- MapDB for AutoSYNC created.
--- SysDB updated
--- Changes will take effect when the Monitor is restarted.
* Error * The monitor process $ZASZ is not executing.
* 652 * To start a monitor, issue the START MONITOR command.
--- Starting Monitor process $ZASZ
AutoSYNC Monitor 1.8.2 - 31AUG2007 -- $ZASZ (3,727) - System \ATOM
Started at Aug 31 2007 18:14:21, elapsed time = 0:00:01
Backup process $ZASZ (2,1052), no takeovers
Monitor hometerm: $0