HP NonStop G-Series User Manual
Page 132
Command Interpreter
HP AutoSYNC User’s Guide—522580-016
8-40
ALTER SYNCFILESET
a file set on the local system that is the source of the synchronization
operation. If a system name is specified, it must be the local Expand node
name.
For file set formats, see
FROMO[WNER] user-id | NO FROMOWNER
instructs Autosync to (or not to) synchronize only the source files owned by the
specified user ID. By default the whole source fileset is synchronized,
regardless of the ownership of the files, as long as security settings do not
prevent it.
An OSS directory that is not owned by the specified owner is skipped, along
with all its files and subdirectories, even if some of the subordinate files or
subdirectories are owned by the specified user ID.
[IP]HOST[NAME] { tcpip-address | host-name } | NO [IP]HOST[NAME]
(for synchronization over TCP/IP only)
address of the destination system specified as an Internet address or the
configured internet name of the host system.
tcpip-address is specified in the dotted decimal format nnn.nnn.nnn.nnn
(example: 16.107.164.200).
host-name is the name by which the destination system is known on the
internet, specified as a character string of 49 or fewer characters (example:
foxii.cac.cpqcorp.net).
There is no default value for this option. If HOST is omitted, AutoSYNC
performs the synchronization over the Expand link.
INTERVAL interval [ MINUTES | HOURS | DAYS ]
the frequency at which the destination file set is to be updated. The value of
interval is between 1 minute and 366 days. The default unit of time is the
MINUTE. The default interval is 5 minutes.
The interval value is ignored if a START option is specified without a STOP
option; then synchronization occurs once a day at START time.
Note that the interval is the time to delay from the completion of one
synchronization until the start of the next synchronization.
KEEPB[ACKUPINFILE] | NO KEEPB[ACKUPINFILE]
instructs AutoSYNC to retain (or stop retaining) BACKUP and RESTORE input
files. By default, these files are temporary and they are purged after the
synchronization has completed.
This option is used for troubleshooting only.