HP Insight Control Software for Linux - Manual (Page 57)

are numbered sequentially beginning with Logical Drive 1, as required by the Insight Control
server migration. If volumes are not numbered sequentially, clear the configuration and re-create
the necessary volumes.
Static IP address cannot be assigned on the destination server while booting using
the Boot CD ISO
Assigning a static IP address on the destination server might result in an error similar to the following:
The IP address xxx.xxx.xxx.xxx you have entered for this network adapter
is already assigned to another adapter.
Cause
This issue might occur if the IP address is assigned to another network adapter on the destination
server.
Suggested action
Assign a different IP address to the network adaptor or reboot the server.
Supported storage controllers display Unknown on the Boot CD ISO
Cause
If the Insight Control server migration Boot CD ISO blocks the supported storage controllers for
P2P or V2P migrations, the controller might appear as Unknown.
Suggested action
To reset NVRAM on the destination server:
1. Reboot the destination server.
2. Press F9 during reboot to enter ROM-Based Setup Utility (RBSU).
3. Open Advanced Options, and then select Restore Settings/Erase Boot Disk or Clear NVRAM.
4. Reboot the system by using the Insight Control server migration Boot CD ISO. The proper
storage controller name is detected.
Automatic booting of the destination physical server fails
The destination server does not boot and no error message appears on the application station.
Suggested action
Reset the iLO network settings of the destination server and retry the automatic booting of the
destination server.
Insight Control server migration might not detect virtual machines on mapped network
drives
Cause
Insight Control server migration cannot locate virtual machines stored on mapped network drives
if the service does not have access to the network shares.
Suggested action
Manually migrate these disks after a successful migration.
Destination preparation 57