HP StorageWorks Auto Path VA Software - Manual (Page 59)

59
COMMAND-LINE INTERFACE
The Auto Path command-line interface (CLI) can be used only on hosts
connected to multipath-capable devices with the Auto Path driver installed.
The commands supported by this interface and the syntax are described
here:
• autopath adapters (page 60)
• autopath devices (page 61)
• autopath help (page 62)
• autopath paths device (page 63)
• autopath set device (page 64)
You can execute Auto Path commands only from the directory where the
installed Auto Path program files reside.
To exit the DOS window, use the exit command.
If you chose the default directory when you performed the installation,
change the directory to C:\hpss\AutoPath, and then execute Auto Path
commands. If you chose a different directory during installation, change the
directory to the one you specified, and then execute Auto Path commands.