Changing the profile mode, Access control list commands, Viewing the acl – HP StorageWorks 1000 Modular Smart Array User Manual
Page 43: Basic command, Command options, Example command and response

HP StorageWorks 1000/1500 Modular Smart Array Command Line Interface user guide
43
Changing the profile mode
This command changes a host profile mode based on the number of the mode that is displayed in the
show profile
command.
CAUTION:
Use only under the advise of an authorized customer support technician.
Basic command
change mode
Command options
profileName
—the name of an existing profile.
hostModeNumber
—the number that is displayed next to the mode in the
show profile
command.
Access Control List commands
When multiple hosts access the storage of the MSA, it becomes necessary to restrict access to LUNs to
specific hosts. The CLI uses an Access Control List (ACL) to enter the list of LUNs a host can access.
NOTE:
Even in the same OS environment, if multiple servers and HBAs have access to the same LUN, all
of the HBAs must be of the same model.
Each of the following commands is used to set up and manage the ACL:
• Viewing the ACL
• Adding to the ACL
• Deleting information from the ACL
Each of these tasks is defined in the following sections.
NOTE:
Use the
show connections
command to display the connection name, defined profile type,
and the WWPN of each HBA connected to the MSA.
The connection name or the WWPN is required when entering ACL information. See
on page 19 for a sample display.
Viewing the ACL
To display the current ACL:
Basic command
show acl
Example command and response
CLI> show acl
ACL is enabled:
Connection WWPN Units
ABC 11111111-22222222 0,1,2
XYZ 33333333-44444444
3,4
Inaccessible Units: 5,6