Deleting the user-defined name of a connection, Creating a new profile, Moving to a different profile – HP StorageWorks 1000 Modular Smart Array User Manual
Page 42: Basic command, Command options, Example command and response, Example command

42
Using the CLI
Deleting the user-defined name of a connection
To remove the user-defined name associated with a connection to a host:
Basic command
delete connection
Command options
connection_name
—the nickname that was assigned to the HBA within the host.
Example command and response
CLI> delete connection MSA-1
Connection(s) has been deleted successfully.
Creating a new profile
This command creates a new host profile.
Basic command
add profile
Command options
profileName
—the name of a new profile.
Moving to a different profile
This command copies the profile settings of a valid, pre-defined profile into a different profile.
NOTE:
If you are migrating from active/passive to active/active firmware and did not set your profile (it is
still set to
default
), you can use this command to copy the settings for a valid profile (such as
Windows
)
into the default profile.
However, HP recommends using the
set connection
command to properly set the host connection. For
details, see ”
Changing the profile of a connection” on page 41
.
Basic command
copy profile
Command options
sourceName
—the name of an existing, valid profile whose settings you want to copy.
destinationName
—the name of the profile (such as
Default
) that is importing the settings.
Pre-defined profiles include:
Default
—is not operating-system specific and should not be used; use a valid pre-defined
name.
Windows
OpenVMS
Tru64
Linux
Solaris
Netware
HP
Example command
CLI> copy profile Windows default