Changing the profile of a connection, Changing the user-defined name of a connection, Basic command – HP StorageWorks 1000 Modular Smart Array User Manual
Page 41: Command options, Example command and response

HP StorageWorks 1000/1500 Modular Smart Array Command Line Interface user guide
41
Changing the profile of a connection
To change the operating-system profile associated with an existing connection (or to change the HBA of a
connection):
NOTE:
The connection profile is sometimes referred to as the Host Mode.
Basic command
set connection
[offset=offset_value]
Command options
ConnectionName
—the name of the connection to modify.
wwpn=xxxxxxxx-xxxxxxxx
—the WWPN of the connection to modify, using the WWPN of the
HBA. The “show connections” can be used to obtain the WWPN.
profile=profile_name
—the platform of the host. Options include:
Default
—is not operating-system specific and should not be used; use a valid pre-defined name.
Windows
OpenVMS
Tru64
Linux
Solaris
Netware
HP
offset=offset_value
—(default: 0) the unit offset for assigning logical volumes.
Example command and response
CLI> set connection MSA-1 profile=windows
The profile of connection MSA-1 is set to Windows successfully.
Changing the user-defined name of a connection
To change the user-defined name associated with a connection:
Basic command
rename connection
Command options
old_connection_name
—the name of the connection that is to be changed.
new_connection_name
—the new name to assign to the connection, up to 16 alphanumeric
characters.
Example command and response
CLI> rename connection abc xyz
Connection(s) has been renamed successfully.