HP 3PAR StoreServ 7000 Storage - Manual (Page 7)

1 Prepare to Configure
Prerequisites
CAUTION: You must complete the setup tasks detailed in the HP 3PAR StoreServ 7000 Storage
Installation Guide before using SmartStart to configure your system.
To access the HP 3PAR StoreServ 7000 Storage Installation Guide, go to the HP 3PAR StoreServ
Storage site and click the Support link for your product:
http://www.hp.com/go/3par
CAUTION: A DHCP network is required to setup a virtual service processor or SmartStart will
fail to complete.
NOTE: The service processor and StoreServ must be on the same subnet.
Before you configure your new HP 3PAR StoreServ 7000 Storage system:
•
Verify the following setup tasks are complete, as described in the HP 3PAR StoreServ 7000
Storage Installation Guide:
◦ All components are installed.
◦ If you are using a Virtual Service Processor, the system time must be set to the correct
time of day on the ESXi Host.
7