HP 3PAR StoreServ 7000 Storage - Manual (Page 14)

3 Setting Up the HP 3PAR StoreServ Storage System
You must initialize the HP 3PAR StoreServ Storage system before you can configure the storage
system. The Storage System Setup wizard verifies your HP 3PAR storage system configuration,
initializes the storage system, and runs initialization tests on the storage system.
To set up and configure the HP 3PAR storage system:
1. Verify the Service Processor is on the same subnet of the network as the HP 3PAR StoreServ
7000 Storage system you are setting up.
2. Click the Set up the Storage System link in SmartStart wizard Step 2, Set up systems.
3. Enter the permanent Service Processor IP address. For more information on Service Processor
IP addresses, see the HP 3PAR StoreServ 7000 Storage Installation Guide.
4. Enter the username setupusr.
5. Enter the password for setupusr you created in the Service Processor Setup wizard.
Troubleshooting Access
If you are unable to access the Storage System Setup wizard, collect the relevant log files and
contact HP support. For more information, see
“Troubleshooting System Setup” (page 17) .
Locating the Serial Number
The 7-digit storage system serial number is located on the back of your HP 3PAR StoreServ Storage
system next to the power switch for the node enclosure
PCM , and begins with 16 (e.g., 1612345).
14 Setting Up the HP 3PAR StoreServ Storage System