HP Command View EVA Software - Manual (Page 50)

Figure 13 P6000 EVA iSCSI/FCoE controller enclosure (rear view)
Resynchronizing controllers
If a controller is in an inconsistent operational state or code load to the controller has timed out,
you can resynchronize the firmware without restarting the controller.
To resynchronize a controller:
1.
From Storage System point of view, select the controller that you want to resynchronize.
The Controller Property page opens.
2. Under the General tab, click Shut down.
The Shut Down Controllers window opens.
3. Under Controller Shutdown, click Resync.
A confirmation window opens.
4. Click Continue.
The firmware restarts and the controllers get resynchronized from the firmware image.
Hardware
Depending on the array storage system, hardware can typically include iSCSI devices, racks
(cabinets), controller enclosures, and disk enclosures (physical disk drives).
Working with hardware in HP P6000 Command View
The hardware folder for an HP P6000 EVA storage system includes all detected hardware.
EVA4000/4100/6000/6100/8000/8100 also displays a list of unmappable hardware (hardware
can be unmappable due to an error condition, hardware failure, or restart state). The following
graphic shows a sample hardware folder. The display will vary, depending on your storage system
type.
(only a portion of the display is shown)
In the various hardware pages you can view hardware information, operational status, and perform
actions. For example, with controller pages, you can view general information, operational status,
50 Maintaining and managing HP P6000 EVA storage systems