Important safety instructions – HP Scanjet Pro 3000 s2 Sheet-feed Scanner User Manual
Page 54
Additional ENERGY STAR qualified imaging product model information is listed
Important safety instructions
Read all these instructions, and follow all warnings and instructions marked on the scanner.
●
In this document, warnings, cautions, and notes indicate the following:
◦
Warnings must be followed carefully to avoid bodily injury.
◦
Cautions must be observed to avoid damage to your equipment.
◦
Notes contain important information and useful tips on the operation of this product.
◦
Place the scanner close enough to the computer for the interface cable to reach it easily.
Do not place or store the scanner or the AC adapter outdoors, near excessive dirt or dust,
water, heat sources, or in locations subject to shocks, vibrations, high temperature or
humidity, direct sunlight, strong light sources, or rapid changes in temperature or humidity.
Do not use with wet hands
◦
Use only the AC adapter that comes with your scanner. Using any other adapter could
cause fire, electrical shock, or injury
CAUTION:
Be sure the AC power cord meets the relevant local safety standards.
●
The AC power cord should be placed to avoid abrasions, cuts, fraying, crimping, and kinking. Do
not place objects on top of the AC power cord and do not allow the AC adapter or the AC power
cord to be stepped on or run over. Be particularly careful to keep both of the AC power cords
straight at the ends and the points where they enter the AC adapter.
●
The AC adapter is designed for use with the scanner with which it was included. Do not attempt
to use it with other electronic devices unless specified.
●
Use only the type of power source indicated on the product’s label.
●
When connecting this product to a computer or other device with a cable, ensure the correct
orientation of the connectors. Each connector has only one correct orientation. Inserting a
connector in the wrong orientation may damage both devices connected by the cable.
●
Avoid using outlets on the same circuit as photocopiers or air control systems that regularly
switch on and off.
●
If you use an extension cord with the scanner, make sure the total ampere rating of the devices
plugged into the extension cord does not exceed the cord’s ampere rating. Also, make sure the
total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet’s
ampere rating.
●
Never disassemble, modify, or attempt to repair the AC adapter, scanner, or scanner option by
yourself except as specifically explained in the scanner’s guides.
●
Do not insert objects into any opening as they may touch dangerous voltage points or short out
parts. Beware of electrical shock hazards.
48
Chapter 6 Specifications and warranty
ENWW