Access to the usb port, The key server token led – HP StoreEver MSL Tape Libraries User Manual
Page 8

The LTO-4 tape drive must have the following or later versions of tape drive firmware:
Fibre Channel
SAS
Parallel SCSI
Not Applicable
U26W
W22W
Ultrium 1760
H44W
Not Applicable
B45W
Ultrium 1840
To find the version of firmware on your tape drive, see
“Verify your autoloader or library firmware
.
NOTE:
With the above LTO-4 tape drive firmware revisions, the autoloader or library will NOT
allow LTO-3 media in LTO-4 tape drives when encryption is enabled with the encryption kit. Always
ensure that your tape drive has the most recent firmware version. You can download tape drive
firmware files from the HP Support website at
Access to the USB port
To use the key server tokens included in the encryption kit, the USB port on the back of the
autoloader or library must be accessible. Only the rear USB port on the MSL6480 may be used
for the key server token. On some MSL2024 and MSL4048 libraries you might need to remove
the silver tape covering the USB port.
Figure 2 MSL6480 rear USB port location
Figure 3 Autoloader and other library USB port location
The key server token LED
The key server token has a green status LED, which is visible through the token label.
8
Features and overview