HP Color LaserJet 3800 Printer series - Manual (Page 146)

Control panel message Description Recommended action
REPLACE CARTRIDGE
alternates with
To continue press .
The print cartridge is nearing the end of its
useful life and the REPLACE SUPPLIES
setting in SYSTEM SETUP is set to STOP AT
LOW. To override, press
.
1. Order the print cartridge.
2. Press to continue.
or
Press for help.
See Supplies and accessories for more
information.
REPLACE SUPPLIES
alternates with
For status press
At least two print cartridges are out and need
to be replaced. 1. Press to identify which supplies
should be replaced.
2. Press for help.
See Replacing supplies and parts for more
information.
See Supplies and accessories for more
information.
REPLACE SUPPLIES
alternates with
To continue press
More than one supply item is low, and the
REPLACE SUPPLIES setting in SYSTEM
SETUP is set to STOP AT LOW. 1. Press Menu and navigate to the
SUPPLIES STATUS menu in order to
identify which supplies should be
ordered.
2. Order the supplies.
3. Press to continue printing.
See Supplies and accessories for more
information.
REPLACE SUPPLIES
Override in use
alternates with
Ready
At least one print cartridge is out, but printing
is continuing. Print-quality problems might
occur. 1. Press to identify which supplies
should be ordered.
2. Order the identified supplies.
See Supplies and accessories for more
information.
REPLACE SUPPLIES
Using black only
alternates with
Ready
At least one color print cartridge is out.
Printing can continue, but only the black
cartridge is being used. 1. Press to identify which supplies
should be ordered.
2. Order the identified supplies.
See Supplies and accessories for more
information.
Request accepted please wait The printer has accepted a request to print an
internal page, but the current job must finish
printing before the internal page will print. No action necessary.
Resend upgrade The firmware upgrade was not successful. Attempt the upgrade again.
Restoring factory settings The printer is restoring factory settings. No action necessary.
Restoring... The printer is restoring settings. No action necessary.
RESTRICTED FROM PRINTING IN COLOR
alternates with
Ready
This message appears only for the HP Color
LaserJet 3000 and 3800 Series printers. HP Color LaserJet 3000: Enable color
printing on the SYSTEM SETUP menu. Set
RESTRICT COLOR USE to ENABLE
COLOR.
132 Chapter 8 Problem solving ENWW