HP Integrity NonStop J-Series - Manual (Page 253)

HP AutoSYNC User’s Guide—522580-018
D-1
D
Error Messages
This appendix describes the EMS messages generated by AutoSYNC. In each
message description, the following information appears:

Message number

Message text

Cause—the condition or error that produced the message

Effect—the effect of the condition or error on the system

Recovery—the steps required to recover from a reported error
The event descriptions are organized as follows:
Informational messages
Critical event messages
Informational messages
100
Cause. The monitor process is initializing itself.
Effect. The monitor process is not ready to service requests until initialization is
completed.
Recovery. Informational message only; no corrective action is needed.
101
Cause. The monitor process has completed initialization.
Effect. The monitor is ready to service requests.
Recovery. Informational message only; no corrective action is needed.
102
Cause. The monitor process is stopping due to a user request. The EMS message
identifies the user that made the request.
Monitor initialization
Monitor started
Monitor stopped