P2000 g3 1gb iscsi msa, Typical) – HP P2000 G3 MSA Array Systems User Manual
Page 71
HP P2000 G3 iSCSI MSA System User Guide
71
P2000 G3 1Gb iSCSI MSA
NOTE:
Once a Link Status LED is lit, it remains so, even if the controller is shutdown via SMU or CLI.
When a controller is shutdown or otherwise rendered inactive —its Link Status LED remains
illuminated—falsely indicating that the controller can communicate with the host. Though a link exists
between the host and the chip on the controller, the controller is not communicating with the chip. To reset
the LED, the controller must be properly power-cycled (see
Table 16
LEDs — HP P2000 G3 1Gb iSCSI MSA LFF and SFF rear panel
LED
Description
Definition
1
Power supply LEDs
See
2
Host 1Gb iSCSI Link Status
Host 1Gb iSCSI Link Activity
Off — The port is empty or the link is down.
Green — The port is connected and the link is up.
Off — The link is idle.
Blinking Green — The link has I/O activity.
3
OK to Remove
Off — The controller module is not prepared for removal.
Blue — The controller module is prepared for removal.
4
Unit Locator
Off — Normal operation.
Blinking white — Physically identifies the controller module.
5
FRU OK
Off — Controller module is not OK.
Blinking green — System is booting.
Green — Controller module is operating normally.
6
Fault/Service Required
Amber — A fault has been detected or a service action is required.
Blinking amber — Hardware-controlled power-up or a cache flush
or restore error.
7
Network Port Activity
Off — The Ethernet link has no I/O activity.
Blinking green — The Ethernet link has I/O activity.
8
Network Port Link Status
Off — The Network port is not connected or the link is down.
Green — The Network link is up.
9
Cache Status
10
Expansion Port Status
Off — The port is empty or the link is down.
On — The port is connected and the link is up.
S
ERVICE
CACHE
CLI
HO
S
T
S
ERVICE
CACHE
CLI
HO
S
T
6G
b
/
s
6G
b
/
s
L
1
CLI
2
A
L
A
3
4
L
1
CLI
2
A
L
A
3
4
L
A
L
A
L
A
L
A
ACT
LINK
ACT
LINK
1
3
4 5 6
7 8
9
-
1
2
(typical)