Change the front-panel display contrast, Change the units of measurement, Configure network settings – HP Designjet T620 Printer series User Manual

Page 30: Change the graphic language setting

Change the front-panel display contrast

To change the contrast of the front-panel display, select the Setup menu icon

, then Front panel

options > Select display contrast, and enter a value using the

Down

key. Press the

key to

set the value. The default contrast is set to 50.

Change the units of measurement

To change the units of measurement in the front-panel display, select the Setup menu icon

then Front panel options > Select units, and select English or Metric. By default the units are set to
metric.

Configure network settings

To configure the same network settings from the front panel, press the

key to go to the main menu

and select the Connectivity menu icon

. You can view and configure the following network settings.

●

USB: view information about the USB connection

●

JetDirect EIO: view information, configure and reset the JetDirect connection

●

Advanced > Select I/O timeout: specify the number of seconds that an idle connection is allowed
to remain open, 270 is the default value, if set to zero, the timeout is disabled

●

Advanced > Allow SNMP: specify whether SNMP is permitted

●

Advanced > Embedded Web Server > Allow EWS: specify whether the Embedded Web Server
is enabled

●

Advanced > Web Services > Printer Utility software: view the Printer Utility software settings

●

Advanced > Web Services > Color and paper management: view the color and paper
management settings

Change the graphic language setting

NOTE:

You should not need to change the default graphic language setting (Automatic), and you are

not recommended to do so.

You can change the graphic language setting from the front panel. Press the

key to return to the

main menu the select the Setup menu icon

, then Printing preferences > Select graphic

language. Select one of the following options and press the

key to set the value.

●

Select Automatic to let the printer determine which type of file it is receiving. This setting works
for most software applications.

●

Select HP-GL/2 only if you are sending a file of that type directly to the printer, without going through
a printer driver.

ENWW

Change the front-panel display contrast

ings