HP OmniBook 7100 Notebook PC - Manual (Page 15)

English 15
+3(QFU\SWLRQ6PDUW&DUG6HFXULW\6\VWHP8VHU¶V*XLGH
8VLQJWKH6PDUW&DUG6HFXULW\0DQDJHU
Using the Smart Card Security Manager
Note HP recommends that you not change the default administrator settings in
the Smart Card Security Manager unless you are familiar with NT logon
practices.
At the desktop, access the Smart Card Security Manager by clicking Start,
Programs, HP Security System, Smart Card Security Manager.
Smart Card Options
To see the following options, click the Smart Card tab in the Smart Card
Security Manager.
Initialize a Smart Card
A smart card must be initialized before it can be used. This option is
activated only if the administrator settings in the Smart Card Security
Manager allow it. Refer to page 6 for instructions.
Change a Smart Card’s PIN
You can change your smart card’s PIN (Personal Identification Number).
The PIN must be exactly eight digits long and can contain only numbers.
To change the PIN:
1. Run the Smart Card Security Manager and click the Smart Card tab.
2. Click Change PIN .
3. Enter the old PIN, then the desired PIN (twice).
4. Click OK .