HP Netserver L Server series - Manual (Page 8)

Chapter 1 Controls, Ports, and Indicators
2
CD-ROM Eject Button FDD Eject Button
CD-ROM CD-ROM Activity LED FDD Activity LED Flexible Disk Drive
(FDD)
SCSI Disk ID 0 SCSI Disk ID 1 SCSI Disk ID 2
Figure 1-2. Input and Storage Device Controls
Table 1-1. Power Switch and Indicators
Control/Indicator Description
Power On/Off/Sleep
Switch
Push-button
Switch
This push-button switch turns the HP Netserver power On
or Off, and if available, also transitions the Netserver
between Power On and sleep states. If sleep states are not
available, then this button only turns power On or Off.
The sleep states are NOS dependent and not available if
your NOS does not support power management based on
the ACPI (Advanced Configuration and Power
Management Interface) standard. Refer to "Applying
Power to the HP Netserver" and "Sleep States (ACPI)"
later in this chapter.
On/Off/Sleep LED
LED
This green LED provides the power state of the Netserver:
• Steady Green when the Netserver is operating
normally
• Blinking Green at 1-Hz rate indicates the Netserver is
in a sleep state and under ACPI control
• Off (unlit) when the Netserver is powered off or in
standby
Reset Switch
RESET
Push-button
Switch
This push-button momentary switch creates a hard system
reset. This is the equivalent to a power-on reset.