HP Netserver L Server series - Manual (Page 15)

9
2 Opening and Closing the HP
Netserver
Introduction
This chapter describes how to the remove the top cover, front bezel, and the air
duct from the HP Netserver LP 1000r.
WARNING Before removing the top cover, always disconnect the power
cord and unplug telephone cables. Disconnect the power cord
to avoid exposure to high energy levels that may cause burns
when parts are short-circuited by metal objects, such as tools
or jewelry. Disconnect telephone cables to avoid exposure to
shock hazard from telephone ringing voltages.
Tools Required
The following tool may be needed to remove the air duct for the first time:
• ¼-inch flat blade screwdriver (for the air duct)
Removing the Front Bezel
The front bezel is provided to protect the power and reset switches from accidental
disabling.
To remove the front bezel, follow these steps:
NOTE You do not need to removal the front bezel to remove the top
cover of the Netserver. You do need to remove the front bezel
to install mass storage devices or media.
1. If the Netserver is operating, you do not need to turn off power to remove the
front bezel.
2. Release the front bezel by placing your hand at the center of the half-moon
opening in center of the front bezel. See Figure 2-1.
3. Pull out towards you on the front bezel.
The bezel rotates down to approximately an 80 ° angle.