HP Netserver L Server series - Manual (Page 109)

Chapter 12 Troubleshooting
103
Mouse error
(The LP 1000r
will complete the
boot process
without a mouse
connected.) • Verify the mouse is connected to the correct
connector (not the keyboard connector) at the rear of
the Netserver.
• Verify the connector is pushed completely.
If the problem persists, replace the mouse or
contact your HP support organization.
If no message
appears (screen is
blank) • If no text or messages appear listen for the beep
codes. Refer to the beep codes listed in the HP
Netserver LP 1000r Service Manual.
• If no message appears but the Netserver stops after
POST, verify the DIMMs are correctly installed.
• If you suspect the BIOS is corrupted, refer to
"Clearing the CMOS Configuration," and restart the
Netserver.
If a config-
uration error
occurs If a Netserver configuration error is reported during the
startup routine, clear the CMOS memory as described
under "Clearing the CMOS Configuration," and restart
the Netserver.
System CMOS
checksum bad • Press to run Setup.
• Change settings as required.
• Choose the Exit option, selecting Save Changes and
Exit to save the new settings.
The Netserver should reboot.
Power-On Self Test (POST) Error Codes
These error codes (POST codes) appear in normal video if an error condition
occurs during the boot process of the HP Netserver LP 1000r. All the codes and
the respective descriptions are listed in the HP Netserver LP 1000r Service
Manual, but not all the codes apply to this Netserver. The service manual is also
located on the HP Netserver Online Documentation CD-ROM, provided with the
HP Netserver.
These codes will appear on the display monitor, provided it and the supporting
circuitry are functioning.
NOTE Do not take remove/replacement actions until you have taken
other troubleshooting steps. See the troubleshooting checklist.