HP Netserver L Server series - Manual (Page 43)

Chapter 5 Installing Additional Boards
37
Remote Control Card
The HP Netserver LP 1000r supports the HP Remote Control (PCI) card, which makes
use of the HP TopTools remote management software. The Remote Control card requires
an I
2 C connection to the system board, which is provided by the I 2 C connector on the
daughter board (Integrated Remote Assistant circuitry) installed onto the system board.
See Figures 5-1 and 5-2.
Integrated Remote Assistant
Board (daughter board)
I C
Connector 2
Figure 5-1. Integrated RA Board Connector (I 2 C)
NOTE The daughter board has the circuitry for Integrated Remote
Assistant (Integrated RA) and the I
2 C connector for connection
to a Remote Control board. For more information on the use of
the HP TopTools function, refer to Chapter 10, "Configuring
the HP Netserver," and Chapter 11, "HP Netserver Online
Documentation CD-ROM."