Reboot the server, Connecting the cables to the tape drive – HP StoreEver Ultrium Tape Drives User Manual

Page 39

Connect the SAS and power cords to the tape drive and plug the other end of the power cord
into the power outlet.

3. Power on/off switch

1. SAS connector

2. Power connector

Figure 25 Connecting the cables to the tape drive

Reboot the server

Switch on the tape drive and power up the server. The power on/off switch is on the front panel.

Watch the boot screen carefully after installation. If there are any error or unexpected messages go
back and check the SAS cabling carefully.

If this does not resolve the problem, refer to “

” on page 61 for further guidelines.

Ultrium Half-Height SAS Tape Drives