Asus NCCH-DR User Manual
Page 81
A S U S N C C H - D R
A S U S N C C H - D R
A S U S N C C H - D R
A S U S N C C H - D R
A S U S N C C H - D R
4 - 1 9
4 - 1 9
4 - 1 9
4 - 1 9
4 - 1 9
H e a d
H e a d
H e a d
H e a d
H e a d
Shows the number of the hard disk read/write heads.
Precomp
Precomp
Precomp
Precomp
Precomp
Displays the precompressed volumes on the hard disk, if any, on the
motherboard.
Landing Zone
Landing Zone
Landing Zone
Landing Zone
Landing Zone
Displays the drive’s maximum usable capacity as calculated by the BIOS
based on the drive information you entered.
Sector
Sector
Sector
Sector
Sector
Shows the number of sectors per track.
Transfer Mode
Transfer Mode
Transfer Mode
Transfer Mode
Transfer Mode
Shows the data transfer mode if the IDE hard disk drive supports the
feature. Otherwise, this item is grayed out and shows the value [None].
S.M.A.R.T. Status
S.M.A.R.T. Status
S.M.A.R.T. Status
S.M.A.R.T. Status
S.M.A.R.T. Status
Shows the Smart Monitoring, Analysis, and Reporting Technology
(S.M.A.R.T.) status if the IDE hard disk drive supports the feature.
Otherwise, this item is grayed out and shows the value [None].
After entering the IDE hard disk drive information, use a disk utility, such
as FDISK, to partition and format new IDE drives. This is necessary so
that you can write or read data from the hard disk. Make sure to set the
partition of the Primary IDE hard disk drive to “Active.”
4.3.2
4.3.2
4.3.2
4.3.2
4.3.2
Primary IDE Slave
Primary IDE Slave
Primary IDE Slave
Primary IDE Slave
Primary IDE Slave
When configuring a drive as Primary IDE Slave, refer to section “4.3.1
Primary IDE Master” for the menu item descriptions.
4.3.3
4.3.3
4.3.3
4.3.3
4.3.3
Secondary IDE Master
Secondary IDE Master
Secondary IDE Master
Secondary IDE Master
Secondary IDE Master
When configuring a drive as Secondary IDE Master, refer to section “4.3.1
Primary IDE Master” for the menu item descriptions.
4.3.4
4.3.4
4.3.4
4.3.4
4.3.4
Secondary IDE Slave
Secondary IDE Slave
Secondary IDE Slave
Secondary IDE Slave
Secondary IDE Slave
When configuring a drive as Secondary IDE Slave, refer to section “4.3.1
Primary IDE Master” for the menu item descriptions.