Asus NCCH-DR - Manual (Page 80)

4 - 1 8 4 - 1 8 4 - 1 8 4 - 1 8 4 - 1 8 C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p
Before attempting to manually configure an IDE drive, make sure that
you have the correct configuration information supplied by the drive
manufacturer. Incorrect settings may cause the system to fail to
recognize the installed IDE drive!
UDMA Mode [Auto] UDMA Mode [Auto] UDMA Mode [Auto] UDMA Mode [Auto] UDMA Mode [Auto]
When this item is set to [Auto], the UDMA capability allows improved
transfer speeds and data integrity for supported IDE drives. Configuration
options: [Disabled] [Auto]
Manually detecting an IDE drive
If you wish to manually enter the drive information, set the Primary IDE
Master item to [Manual], and the Access Mode item to [CHS].
To manually enter the number of cylinder, head, precomp, landing zone,
and sector per track for the drive, highlight an item, key-in the value that
you obtained from the drive documentation, then press . Refer to
the drive documentation or the drive label for this information.
To enter a value, you may also highlight the item, then press to
display a pop-up menu. Type in the value from the drive documentation,
then press .
Capacity [xxxxx MB] Capacity [xxxxx MB] Capacity [xxxxx MB] Capacity [xxxxx MB] Capacity [xxxxx MB]
Displays the auto-detected hard disk capacity. The value is not
user-configurable.
Cylinder Cylinder Cylinder Cylinder Cylinder
Shows the number of the hard disk cylinders.
Primary Master
Primary IDE Master [Manual]
Access Mode [CHS]
Capacity 0 MB
Cylinder [ 0]
Head [ 0]
Precomp [ 0]
Landing Zone [ 0]
Sector [ 0]
PIO Mode [Auto]
UDMA Mode [Auto]
Transfer Mode None
S.M.A.R.T Status None
Select Menu
Item Specific Help
Selects the type of
fixed disk connected to
the system. ‘Manual’
will let you select the
number of cylinders,
heads, etc.
Note: PRECOMP=65535
means none!