LG CF3DAT - Manual (Page 14)

Installation and Configuration
14
Installation and Configuration
Place the projector in a well-ventilated environment.
Do not place the projector in a hot or humid environment.
ꔈ Only install the projector in a place of moderate temperature and low humidity.
(See page 57 regarding operating temperature and humidity.)
Do not place the projector in a place where it will easily collect dust.
ꔈ There is risk of fire.
The projector is manufactured using high-precision technology. You may, however, see tiny black dots and/or bright col-
ored dots (red, blue or green) that continuously appear on the projector screen. This is a normal result of the manufactur-
ing process and does not indicate a malfunction.
Caution on Installation
The remote control may not work in an environment where a lamp equipped with electronic ballasts or a three-wave-
length fluorescent lamp is installed.
Replace the lamp with an internationally standardized lamp for the remote control to work normally.
Do not remove any covers except for the lens cap. There is a high risk of electric shock.
ꔈ To prevent internal heat build-up, install the projector in a
well-ventilated place. Do not place anything near the projec-
tor as this may block its air vents. If the air vents are
blocked, the internal temperature will increase.
ꔈ Do not place the projector on a carpet or rug. This may pre-
vent proper ventilation at the bottom of the projector. This
product should be mounted onto a flat surface or ceiling
only.
ꔈ Be sure to prevent foreign objects such as paper debris from
entering the projector.
ꔈ Leave an adequate distance (30 cm or more) around the
projector.