Bosch HGIP054UC - Manual (Page 6)

English 3
Replace Cooktop Orifices
1. Remove Grates, Burner Caps and Burner Bases.
Unscrew two (2) T20 screws inside each base and
remove burner bases. Reinsert screws in jet holder to
hold tubing assembly in place.
2. Remove Natural Gas Cooktop Orifices.
Insert the socket driver with 3" minimum extension into
the jet holders to remove existing orifices. Set natural
gas orficies aside.
3. Assemble LP Cooktop Orifices.
Place in cooktop exactly as laid out in the orifice card. If
the orifices become separated from the card,
placement can be determined by matching the number
and/or color on the orifice with the placement
specifications displayed in the chart on the card
4. Place the new orifice into the socket then insert each
orifice into its respective threaded hole in the jet holder.
Tighten until the orifice stops turning. DO NOT OVER
TIGHTEN.
5. Remove screws to replace burner base, burner cap
and burner grate. Replace screws.
Note: Burner cap must be properly positioned on
burner base for burner to light.
6. Place natural gas orifices in back of card for future
conversion back to natural gas.
Convert Cooktop Valves for Propane
Use
1. Verify that all knobs are in the OFF position
2. Remove knobs (pull straight out)
3. Insert 1/8” (or smaller) flat head screwdriver into shaft
and turn bypass screw clockwise until it stops (bypass
screw is inside shaft). DO NOT OVERTIGHTEN.
4. Replace knobs.
If your range is dual fuel your conversion is complete.
Replace the cover plate and warming drawer and pro-
ceed to “Test the Installation” on page 4.
For gas range conversions, continue to next step.
Adjust Broil Burner Orifice
1. Remove oven door (See section "Removing Oven
Door" in Use and Care manual).
2. Remove Broil Burner Assembly. The broil burner
assembly is attached to the top of the oven cavity with
5 screws. Remove screws and gently pull broil burner
assembly straight out being careful not to detach
electrical wires. Place broil burner against back wall of
oven cavity.
3. Use 1/2 inch (13 mm) wrench to remove the natural
gas orifice and install the separate LP gas orifice
provided. The orifice is located inside the oven cavity at
the top right (visible with burner assembly removed.)
Burner Grate
Burner Cap
Burner Base
Orifice
Ignitor
LO
HI
SIM
Bypass Screw Inside Shaft