Canon LV-8320 - Manual (Page 61)

Setting
61
Input Source Information Display
The Information Menu is used for checking the status of the image signal being projected and the
operation of the projector.
H-sync freq.
V-sync freq.
Lamp counter
Information Menu
The horizontal frequency of the input signal is
displayed in KHz, or - - - - KHz when no signal.
The vertical frequency of the input signal is
displayed in Hz, or - - - - Hz when no signal.
Numbers of Hz doubles when during Interlace.
The cumulative lamp operating time is displayed.
The information menu changes each time you
press the INFO. button on the remote controller
as follows.
page 1/2  page 2/2  hide  page 1/2 • • • •
While the information menu is displayed, press
the Point ◄ ► buttons to display the previous or
next page.
INFO. button
Remote controller
Press the Point ▲▼ buttons to select the
Information. The Information Menu is displayed.
See below for displayed information.
Power management mode
Aspect
Off, Standby or Exit, and Timer are displayed.
The selected Screen size is displayed.
Input
Lamp status
The selected input source is displayed.
The selected lamp mode is displayed.
Language
The selected language is displayed.
Key lock
The selected Key lock icon is displayed.
PIN code lock
Off or On 1 or On 2 is displayed.
Remote control
The selected remote code is displayed.
Direct Operation
Menu Operation
SERIAL NO.
The serial number of the projector is displayed.
The serial number is used to service the
projector.
Information
Total power savings
The saved amount of power and the exhausted
CO2 are displayed.