Canon LV-8320 - Manual (Page 29)

Basic Operation
29
Choose either COMPUTER 1 (ANALOG PC) or COMPUTER 2 (ANALOG PC) by pressing the
COMPUTER 1 or COMPUTER 2 button on the remote controller. Or you can press the INPUT button
on the top control to choose the desired input source.
Before using these buttons, correct input source should be selected through Menu operation as
described below.
1
Input Menu
2
3
 Note:
When the Auto input function is set to On 1 or On
2 in the Auto setup function, the input signal will be
searched automatically (p.47).
COMPUTER 1
Remote controller
Press the MENU button to display the
On-Screen Menu. Use the Point ▲▼
buttons to select Input and then press the
Point ► button or the OK button.
Use the Point ▲▼ buttons to select
COMPUTER 1.
When COMPUTER 1 is selected, press
the Point ► button to access the submenu
items. Use the Point ▲▼ buttons to select
the ANALOG PC input source and then
press the OK button.
COMPUTER 1(SCART)
Input Source Selection (ANALOG PC: COMPUTER 1/COMPUTER 2)
COMPUTER 2 (ANALOG PC)
Direct Operation
Menu Operation
Computer Input
OR
Use the Point ▲▼ buttons to select
COMPUTER 2 and then press the OK
button.
COMPUTER 1 button
COMPUTER 2 button
COMPUTER 1 (ANALOG PC)
INPUT button
Top Control