Canon REALiS SX80 Mark II D - Manual (Page 57)

57
Adjusting Image
Proje
cti
ng
an
Im
age
AUTO PC
When you press the AUTO PC button if there is a shift in image display or flickering of
screen with the [ANALOG PC-1] or [ANALOG PC-2] selected, the projector is adjusted to
an optimum condition.
The result of adjustment is recorded for each input signal ([ANALOG PC-1] or [ANALOG
PC-2]). If you connect the projector to the same computer, you can project the image with
the same settings as before simply by select the input signal.
■Performing the Auto PC Function
Press the AUTO PC button to make projector adjustment.
Perform the following if the project image has not been properly adjusted with the auto PC
function.
• From [Input signal select], select an input signal type based on the resolution of the com-
puter. ( P80 )
• If the adjustment is still insufficient, from [Input signal settings] select [Total dots], [Track-
ing], [Horizontal position], [Vertical position], [Horizontal pixels] and [Vertical pixels] to
make adjustments. (
P81 – P84 )
• For the signal types supported by the projector, see the table on page 150 .
Remote control Top control