Canon REALiS SX80 Mark II D - Manual (Page 135)

135
Setting Network (SX80 II)
Conn
ec
tin
g the Projector to
N
etwork (SX80 II)
■Error Notification Message
It sends the following message when an error occurs in the projector.
Error list
* Contact your Canon dealer.
Errors related to
temperature
Error name Temperature abnormality
Text
The temperature inside the projector is too high for some
reason or the outside air temperature is higher than the
specified one. If the problem is inside the projector,
check whether the projector is installed and operated
normally, turn off the projector to cool its inside, and retry
projection. If the same warning occurs again, the projec-
tor may be defective. Contact your dealer.
Errors related to
the lamp
Error name Faulty lamp
Text
The lamp has burnt out. Replace the lamp with a new
one. If the same warning occurs again, the lamp drive
circuit may be defective. Contact your dealer.
Errors related to
the lamp cover
Error name Faulty lamp cover
Text
The lamp cover is open. Check whether the lamp cover
is installed properly. If it is installed properly, the lamp
cover detection switch may be defective. Contact your
dealer.
Errors related to
the cooling fan
Error name Faulty cooling fan
Text
The cooling fan or another component may be defective.
Contact your dealer.
Errors related to
the power supply
Error name Faulty power supply
Text
The voltage of part of the power supply is abnormally
high or any other problem has occurred in the power
supply. Contact your dealer.
Other types of
errors Error name Unknown Error
Text Codes in hexadecimal numbers*