Canon REALIS WUX10 MARK II D - Manual (Page 92)

Setting the Image Quality
92
Adjusting Fine Color Adjustment (6-axis
color adjust)
[Advanced adjustment] - [6-axis color adjust]
You can make fine color adjustment with
RGB (red, green, blue) and CMY (cyan,
magenta, yellow). For the details of 6-axis
color adjust, refer to the page
135 .
When you have completed the adjust-
ment, press the MENU button.
• [Off] is the factory default.
• The adjustment you have made is
stored as an adjusted value of input sig-
nals being projected in an image mode.
Correcting the Image According to the
Ambient Light
[Ambient light]
You can correct and project an image
more appropriately according to the ambi-
ent light on the screen if you have
selected [Photo] for [Image mode].
HDMI COMPONENT
DIGITAL PC VIDEO
ANALOG PC
Off Disables the 6-axis color adjustment.
If you select [Adjust], the previous set-
ting of 6-axis color adjustment
becomes active again.
Adjust Enables the 6-axis color adjustment.
Use [ ] / [ ] to select [ Hue] or [
Saturation], then adjust them with [<] /
[>].
Reset Returns any adjustment values to zero.
Advanced adjustment
Image adjustment
6-axis color adjust
<
<
HDMI COMPONENT
DIGITAL PC VIDEO
ANALOG PC
Off Projects an image with no correction.
Adjust You can specify the type and level
(brightness) of the ambient light.
Type Tungsten
Select this if the ambient light
source is a light bulb or bulb color
fluorescent.
Fluorescent
Select this if the ambient light
source is a day white fluorescent.
Fluorescent H
Select this if the ambient light
source is a daylight fluorescent.
Ambient light
Image adjustment