Canon REALIS WUX10 MARK II D - Manual (Page 64)

64
Turning Off the Projector
1
Press the POWER button to pop up a window shown at the lower right.
Press the POWER button again while the confirmation message is displayed.
The lamp goes off, the [POWER] indicator starts flashing in red and the cooling fan
starts.
2
Disconnect the power cord from the AC outlet.
It continues to cool down the lamp even after removing the power cord. Thus, you
may move or put away the projector immediately after the use.
With the power cord connected, the LED illumination lamp turns on during cooling cycle.
• You cannot turn the projector on while the cooling fan is in operation.
• If you want to continue projecting, press a button other than POWER or wait until the con-
firmation message disappears.
• Wait at least 5 minutes before turning on the projector when you turn off the projector. It
may shorten the lamp life if you turn on the projector immediately after turning it off.
• Using the projector for a long time may shorten the life of the lamp and internal optical
components.
• Wait until the cooling fan stops before putting the projector in the carrying bag. Do not put
the projector in the carrying bag until the cooling fan stops rotating. The projector may be
damaged due to the heat.
• Attach the lens cap to the lens to protect it and put the projector in the carrying bag.
Replace the adjustable foot to prevent the damage on the projector.
Remote control Top control