Canon DP-V3010 - Manual (Page 6)

6 Handling Precautions
Handling Precautions
Places to avoid using the video display
Do not use the video display in the following places or conditions.
• Places with excessive dust or humidity
• Places that will expose the video display to direct sunlight, smoke (such as from a kerosene heater or other such source)
or steam
• Near heat sources, humidifiers or flammable gas
• Near a window during rain or snow
• Near water or other places that could cause moisture to form on the video display
Screen Handling
• The screen may be damaged if it is left facing strong source of light. Please take precautions when placing it near a
window.
• Do not press firmly on the screen, scratch it or place an object on the screen. It can cause non-uniformity or damage
to the panel.
• The screen and cabinet may become warm during use, but this not a malfunction.
About Backlight
The backlight has a limited service life so its brightness may degrade and color may change due to aging.
About Temporary Screen burn-in
If a stationary image is displayed for a prolonged period, screen burn-in may occur where you see remnants of what
was displayed. This is a characteristic of LCD and is not a failure. However, this is only temporary and will disappear
when playing video.
About the LCD screen
The screen is produced using extremely high-precision manufacturing techniques, with more than 99.99% of the pixels
operating to specification. Less than 0.01% of the pixels may occasionally misfire or appear as black, red, blue or
green dots. In addition, this tendency may increase through long term use due to characteristic of the LCD panel.
These do not constitute a malfunction.
Condensation
If this equipment is brought into a warm room while it is cold or if the room is heated suddenly, condensation may form
on the surface or inside the equipment. Note that the equipment may be damaged if it is used under such condition.
If condensation has formed on the surface or inside the equipment, do not use the video display may get damaged.
Turn the power off and wait until the condensation has evaporated before using the video display.
COP
Y