Canon DP-V3010 - Manual (Page 20)

20 Installation/Connection
Installing the Display Controller on the Rack
The display controller can be installed on an EIA standard compliant 19-inch rack.
CAUTION
• Make sure that the display controller does not fall during installation/removal.
1. Place the display controller on the rack mount bracket RB-01 as shown in the figure and match the screw
holes.
Make sure the cable does not get caught in the rack mount bracket during installing.
Display Controller
(Back side)
Rack Mount Bracket RB-01
(Back side)
Rack Mount Bracket Screw
SW-02
Rack Mount Bracket Screw
SW-02
2. Insert the rack mount bracket screw SW-02 into the rack mount bracket screw holes at the back and
tighten the screws to secure the display controller.
3. Mount the display controller on the rack using commercially available rack mount bracket screws.
Use screws appropriate for the rack.
Mount on commercially available rack
Mount on commercially available rack
COP
Y